Talkaphone VOIP-600H Single Button Help IP Call Station - Manual (Page 29)

VOIP-600 Series Phone
Configuration / Operation Manual
Page 29 of 94 Rev. 9/17/2014
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4.6.2. Hook Switch
The Hook switch configuration page configures the numbers to be dialed when the handset goes off-hook.
This configuration page is only available for the 0BH device mode.
L ogin → Devices → Hookswitch
Figure 13 Hookswitch
To configure the Hook switch:
1. Click the drop-down menu to assign a Number List. Phone Numbers from the Number List are dialed in
round robin fashion when the handset goes off-hook.
2. Select the Call Priority. This parameter assigns a priority to the call that is generated when the
handset goes off-
hook. A call with a “Call Priority” of 1 terminates all the existing calls having the call
priority in the range of 2 –10.
3. Select the Network Priority
5
to assign a network priority to the placed call. The value is utilized by
the network to prioritize the voice traffic. The default value is 46.
4. Click Apply to save settings.
5 Network priority is the same as Differentiated Services Code Point (DSCP). Do not change this unless absolutely required as it might
degrade the voice quality of the phone.
1
2
4
4
3