Talkaphone VOIP-600H Single Button Help IP Call Station - Manual (Page 92)

VOIP-600 Series Phone
Configuration / Operation Manual
Page 92 of 94 Rev. 9/17/2014
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
++ Valid values : NetworkMode = 1 - DHCP
++ NetworkMode = 3 - STATIC (Default Value)
++ Note : If NetworkMode = 3, must configure following
++ Field name : IPAddress
++ Field name : Netmask
++ Field name : DNSServerIP
++
++ Description : IPAddress - Phone IP Address - mandatory
++ Netmask - The Subnet Mask Address - mandatory
++ Gateway - The Default Gateway address - mandatory
++ DNSServerIP - The DNS Server IP Address - optional
++ Example:
++ NetworkMode = 3
++ IPAddress = 192.168.1.10 (Default)
++ Netmask = 255.255.255.0 (Default)
++ Gateway = 192.168.1.1 (Default)
++ DNSServerIP = (Default blank)
++
++ Note : NetworkMode = 3 (Static) should not applied in bulk update.
++ If applied then all phones will have same Network
++ Settings.
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
NetworkMode = 3
IPAddress = 192.168.1.10
Netmask = 255.255.255.0
Gateway = 192.168.1.1
DNSServerIP =
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++ Field name : Hostname
++ Description : It configures the unique indetifier of the phone at
++ network level
++ Valid Values : 30 chars long, a-z,A-Z,*,0-9,.,-, No space allowed.
++ Default Value is VOIP-600.
++ Note : This Parameter should not be applied in bulk update.
++ If applied then all phones will have same hostname.
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Hostname = VOIP-600
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++ Field name : LogRedirection
++ Field name : LogServerIP
++ Field name : LogServerPort
++ Description : Admin can enable the logging, and route to specific
++ location.
++ Valid values : LogRedirection = 0 - To Disable Logging
++ LogRedirection = 1 - To Console
++ LogRedirection = 2 - To Network
++ LogRedirection = 3 - To File (Append)(Default Value)
++ LogRedirection = 4 - To File (New)
++ Note : If LogRedirection = 2 must configure LogServerIP &
++ LogServerPort
++ Example: