Software structure, Selecting demo mode – BendixKing SKYMAP IIIC User Manual

Page 31

Advertising
background image

QUICK REFERENCE GUIDE

after the GPS has achieved a position fix.

When connected to an appropriate GPS output a “Tracker” unit will self initialise

.

SOFTWARE STRUCTURE

Since the software is tree structured, an analogy can be drawn between the trunk of a tree

and MAIN MENU. This can be accessed after powering on the unit by pressing the HELP
key. MAIN MENU has 5 main software branches, which are as follows:

GPS STATUS: Shows satellite signal

strength, allows UTC, Local Offset,

Date and Position to be set.

FLIGHT PLAN: Allows user defined

waypoints and flight plans to be
edited/created.

QUIC

K REF

E

REN

C

E

NOTEPAD: Allows access to
NOTEPAD and E6-B functions, or

turns off DEMO MODE. DEMO
MODE can only be activated in the

first power on screen.

SET UP: Allows setup of map, NAV,

PIN and input/output characteristics.

MAP: This is the primary mode of the

unit.

As a rule when trying to get to a specific function in another branch of software you should

work your way back down the present branch to MAIN MENU by pressing either the OK,
PREV PAGE, SAVE & EXIT or MAIN MENU key. Then select the branch of software that

contains the desired function you wish to access. There are short cuts allowing you to get
to the primary mode (MAP mode) more easily.

GPS STATUS is replaced with DATA IN/OUT in “Tracker” units. Tracker units will
automatically be configured to accept data from external GPS/LORAN units.

Selecting Demo Mode

Demo Mode allows you to become

familiar with handling your unit on the
ground by turning it into a simulator.

Demo Mode can only be activated in the
first title screen, available at power on.
Press DEMO MODE in the title screen,
and use the joystick to select the start

LAT and LONG and the ground SPEED
you wish to use. Alternatively you can

press the DATABASE key and select a
data point from the database as a start

point (for more information on achieving

this please refer to Database Selection in
this Section of the Manual). Once the

desired LAT/LONG and SPEED is entered press START DEMO.

Rev 9 Jul 2006

2-2

Skymap/Tracker IIIC Pilot's Guide

Advertising