BendixKing SKYMAP IIIC - Manual (Page 33)

QUICK REFERENCE GUIDE
VISUAL DIRECT TO AND DATA INTERROGATION
In MAP mode use the joystick to move
the pointer to the desired location, or
obtain the latitude/longitude and
bearing/distance from present position.
QUIC
K REF
E
REN
C
E
nd
ation
If you have a ground speed your
Bendix/King unit will calculate the time to
reach the tip of the on screen pointer.
This information is displayed in the PETE
(or Pointer ETE) field. If you wish to
invoke the DIRECT TO function press
the DIRECT TO key.
The unit will then provide you with full
navigation information to reach this point.
Alternatively if you wish to obtain more
information on a specific data point, whether it is an airport, a section of controlled
airspace or a beacon, move the pointer onto it and press the MORE INFO key.
Once the pointer has been activated by pushing the joystick it will remain active for 30
seconds; after which time it will automatically reset if not moved. Alternatively you can
force a reset by pressing RESET STICK
DIRECT TO a Specific Latitude- And Longitude
To perform a DIRECT TO a specified latitude/longitude press the DIRECT TO key in MAP
mode when the joystick is not active.
Then press TEMP WPT and use the
joystick to dial in the required latitude a
longitude, followed by ENTER. The unit
will then provide you with full navig
information to reach this point.
Rev 9 Jul 2006 2-4 Skymap/Tracker IIIC Pilot's Guide