Compur STATOX 4120 - Manual (Page 10)

Compur Statox 4120
3. Installation and electrical connections
3.1. Statox 4120 sensor head
3.1.1. Mounting
The sensor head should be installed as close as possible to potential leaks. If it is used as industrial
hygiene device it should be located between a potential leak and personnel working in the area.
Parameters such as:
Air flow (wind, ventilation, thermal conditions)
Access from top (removing the cover) and bottom (loosening the screws)
Specifications of the gas to be detected (specific weight)
Protection from direct sunlight, splash water and dust must be taken care of.
Fasten the sensor head with three nylon screws on the mounting brackets using the rubber bearings
as electrical isolation (these accessories are included).
pic.6: Mounting the sensor head
Mount the sensor head in horizontal position +/ 15%. Assure there is free gas access to the sensor.
10