CANOGA PERKINS 9145ELB Network Interface Device Hardware - Manual (Page 22)

9145ELB NID Hardware User’s Manual Functional Description
Front Panel
8
2.2.2 Network Port Modules
The 9145ELB features a hot swappable Dual 10G Optical Ethernet Network Port module.
2.2.2.1 Dual 10G Optical Ethernet Module
The Dual 10G Optical Ethernet Module ( Figure 2-5) has two SFP+ ports, 10G1 and 10G2. The
SFP+ interfaces support link aggregation and can join the same link aggregation group (LAG).
Figure 2-5 Dual 10G Optical Ethernet Module
2.2.3 Ethernet Management Port
An RJ45 Management port is used for management of the 9145ELB. The management port is
equipped with an MDI and MDIX feature that allows automatic detection cross-over of Tx and Rx
pairs.
The RJ45 port is IEEE 802.3 compliant for 10BASE-T and 100BASE-TX and supports 10 Auto
and 100 Auto modes of operation.
2.2.4 Console Port and Management Interface
The console port is used for communication between the 9145ELB and a VT100 terminal or
emulator.
The console port is an 8-pin modular jack ( Figure 2-6 ) that connects to the terminal with a cable
adapter which can be purchased with the 9145ELB. The console port of the 9145ELB is used for
serial communication between the NID and a VT100 terminal or emulator.
The console port terminates on an 8-pin modular jack, with a DCE pin-out as per “Cisco blue
cable”.