CANOGA PERKINS 9145ELB Network Interface Device Hardware - Manual (Page 39)

Operation 9145ELB NID Hardware User’s Manual
Interface Management
25
Table 4-4. Network Port LED Indicators (SFP and Dual 10G Optical Ethernet Module)
4.4 Interface Management
The 9145ELB is managed locally through the console port and remotely either through the
Management UTP port or inband via the Network Ports. The console port is connected to a VT-
100 terminal, through an emulation program, through the serial port using a RJ45 UTP cable.
OOB is an out-of-band 10/100 Mbps port supporting Telnet, SSH, and SNMP V1/V2C/V3 used
for network management.
4.5 Setting Up the VT-100 Terminal
When using the console port, you can use the HyperTerminal Emulation program that is included
with your Microsoft Windows operating systems. The Telnet session is only available after the
management TCP/IP configuration is completed.
LED Name State Condition
Speed
(SPD)
Off
Port Disabled
Autonegotiate
Green 1000 Mbps
Amber
100 Mbps
System test
Slow Blinking Green* Port enabled but no link
Red Remote fault
Blinking Red Invalid/unsupported SFP installed
Link Activity
(LA)
Off
No link
No transmit or receive activity
Port disabled
Green Link up with full duplex
Blinking Green Transmit or receive activity in full duplex
Amber
System test
Link up with half duplex
Blinking Amber Transmit or receive activity in half duplex
Blinking Red
Link down but transmitting OAM packets in unidirectional
mode
* Slow blinking green means that the LED toggles between Off and Green approximately once per
second.