CANOGA PERKINS 9145ELB Network Interface Device Hardware - Manual (Page 27)

Installation 9145ELB NID Hardware User’s Manual
9145ELB Installation Procedures
13
Chapter 3
Installation
3.1 9145ELB Installation Procedures
This section describes how to unpack, install, and set up the 9145ELB. Before set up, ensure
that an 8-pin cable is available to connect the 9145ELB's console port to a VT100 type terminal
or PC for setup and configuration.
Keep the shipping container and all packing materials until the unit is installed and fully
operational. In the event that the unit needs to be returned, contact Canoga Perkins Customer
Service for a Return Authorization Number (RMA) and instructions for return shipment.
CAUTION: Follow electrostatic discharge (ESD) safety precautions when
handling Canoga Perkins products, as with all electronic devices with static
sensitive components.
3.2 Unpacking
1. Open the shipping container, remove the accessories tray, and remove the accessories
from the tray.
2. Lift the 9145ELB out of the shipping container.
3. Return all packing materials to the shipping container and put it in a safe place in the
event the unit needs to be returned.
NOTE: This equipment must be installed in restricted access areas such as dedicated equip-
ment room, or electrical closet, in accordance with Articles 110-18, 110-26 and 110-27 of the
1999 United States National Electrical Code ANSI/NFPA 70.