CANOGA PERKINS 9145ELB Network Interface Device Hardware - Manual (Page 31)

Installation 9145ELB NID Hardware User’s Manual
Installing a Power Supply Module
17
3.6 Installing a Power Supply Module
Follow these steps to install the power supply module ( Figure 3-5 ):
1. Remove the power supply module from its packaging.
2. Carefully insert the module into the slot, being sure to align the module so it slides along
the guide rails and mates securely with the backplane.
3. Screw in the thumb screw to secure the power supply module to the enclosure.
Figure 3-5 Power Supply Module
3.7 Installing the Network Port Module
Follow these steps to install a Network Port module:
1. Align the module with the rails on either side of the Network Port.
2. Slide the module into the Network Port.
3. Insert and tighten the screws in the chassis.
If no module is installed, the serial port UI will indicate an error condition. You will be prompted to
power down the unit and install a plug-in Network module before powering up again. Opening a
Telnet session will display the same error condition. FTP and SNMP will not function if the
Network Port module is not installed.