CANOGA PERKINS 9145ELB Network Interface Device Hardware - Manual (Page 36)

9145ELB NID Hardware User’s Manual Operation
Port Default Settings
22
Additional information about fault conditions appears in the System Alarms and System Status
and Configuration screens (see the 9145ELB NID Software User’s Manual).
The power and status LEDs, located to the right of the EIA-232 console port, indicate condition
and state of the 9145ELB. The meaning of the power and status lights is described in
Chapter 2,
“Functional Description” .
• Table 4-1. describes the default port settings.
• Table 4-2. describes the Ethernet Management LEDS.
• Table 4-3. describes the LED indicators for User Ports.
• Table 4-4. describes the LED indicators for Network Ports.
4.2 Port Default Settings
Table 4-1. lists the default settings for each port.
Table 4-1. Default Port Settings
• When a 100 Mbps SFP/fiber optic User Port is made active, the default setting is 100M
Full Duplex.
• When a 1000 Mbps SFP/fiber optic User Port is made active, the default setting is 1000M
Full Duplex.
• When a Multi-rate SFP/fiber optic User Port is made active, the default setting is 1000M
Full Duplex.
Module Active Connector Rate/Speed
User Ports 1-8 RJ45 Autonegotiate
User Ports 9-16 SFP/Duplex LC 100M or 1000M FD
Dual 10G Optical Ethernet Module SFP+/Duplex LC 10G FD