Panasonic KX-F700 - Manual (Page 10)

Installation and Preparation
Installing the batteries
The batteries are required to retain voice messages in memory when the power cord is disconnected or
during a power failure. Install four AA batteries (supplied) before using the unit.
) Slide the lever toward you to open the top
cover and remove the battery compartment
cover by pulling the hook toward you and lifting
it up.
^ Install four AA batteries into the compartment
using correct polarity (+, -).
o ® Replace the battery compartment cover by
installing the tab of the cover into the hole
first.
CD Press down the part marked “PRESS” until
it ciicks.
O Close the top cover.
Battery precautions:
• The batteries should be used correctly, otherwise, the unit may be damaged due to battery leakage.
• Do not mix different types of batteries.
• Do not charge, short-circuit, disassemble, heat or dispose in fire.
• Remove all the batteries when replacing.
Notes:
• If you do not install the batteries, or if the battery power is low:
—The display will show the following message;
BATTERY LOW
Install new batteries.
—Greeting and all messages saved in memory will be erased when a power failure occurs.
•Batteries should be installed in order to provide message retention during a power failure. Message
retention time is approximately 1 day with new batteries.
• To avoid losing the greeting and alt messages saved in memory, the power cord must remain connected
when replacing batteries.
• Disconnect the telephone line cord before opening the battery compartment cover.
• Replace all the batteries once a year, or mis-operation may occur.
• Do not use Nickel-Cadmium batteries.
10