Brookfield R/S Coaxial Cylinder Rheometer - Manual (Page 11)

Brookfi eld Engineering Labs., Inc. Page 11 Manual No. M08-219-B1211
III. Instrument Installation
III.1 Mounting the Stand
The stand consists of:
the stand base plate
the stand column with rheometer
A 5 mm Hex wrench and bolt DIN 912 M8 x 40 are supplied for mounting.
The stand column is connected to the stand base plate with a bolt. The proper orientation of the
column is set with a pin in the bottom of the column which fi ts into a hole on the stand base.
Rheometer
Temperature Sensor Pt100
Coaxial Cylinder System
Stand
Base
AC Adapter
Fig. III-1.: Rheometer R/S+ (minimum confi guration)
Hints for height adjustment of the stand:
To change the height adjustment of the stand, you must release the
clamp handle and move the stand to the desired height.
Caution: Hold the rheometer as you release the clamp handle!
You can press the locking button to change the clamp handle posi-
tion without screwing/unscrewing the thread. After adjustment of the
height screw, tighten clamp handle thread.
Fig. III-2.: Stand Height Adjustment Hints
•
•