ChemoMetec SP-100 - Manual (Page 17)

1 Installation
7
If the installation is successful the dialogue shown in figure 10 will appear. Click
“Finish” to complete the installation. The SemenView software and LabVIEW application
are now installed.
Figure 10 Successful installation of the LabView application.
For directions on start-up and use of the SemenView software please refer to chapter 2
Getting started with SemenView
TM on page 11.
1.3 Removal of the SemenView software
For removal of the SemenView software and the USB device driver follow the directions
below.
1.3.1 Removal of the USB driver – Windows 2000
In order to remove the USB device driver make sure that the NucleoCounter SP-100 is
turned On and connected to the computer using the USB cable. Then locate the “My
Computer” icon on the desktop and option-click on the icon (click once using the right
mouse button). Click on “Properties” and the “System Properties” dialogue will appear.
Alternatively open the "System" module of the Control Panel.