ChemoMetec SP-100 - Manual (Page 32)

5 Utility tab
22
If no folder is selected SemenView suggest that the folder from today is selected.
Figure 29 Accept selection of today's folder
Using the button to the right in Figure 28 any folder can be selected as the basis of a
report. Once activated, locate the folder and click “Select Cur Dir”. The file that is
printed is also saved on the hard disk of the PC (see Figure 30). If a report has already
been created and stored, the new report will overwrite the older report.
Figure 30 Location of saved data.
Refer to Appendix 1: Printed report list on page 35 to see an example of a Printed
report list.
5.2 Correction factor
On the NucleoCounter SP-100 a numerical Correction factor can be entered. The default
value is 100.0 %. The present value will be shown in this field.