ChemoMetec SP-100 - Manual (Page 18)

1 Installation
8
Figure 11 “System Properties” dialogue.
In the “System Properties” dialogue select the “Hardware” tag (figure 11) and click on
the “Device Manager” button. A list of system devices will be shown, see figure 12.
Locate “nucleo Device” and open it by clicking on the to the left of the name. This
will show its content, which also has the name “nucleo Device”.
If “nucleo Device” is not on the list, make sure that the NucleoCounter SP-100 is turned
On and connected to the computer and try again.
Figure 12 The Device Manager.