ChemoMetec SP-100 - Manual (Page 26)

4 Analysis tab
16
4.2 Retest of sample
If the NucleoCounter SP-100 suggest to perform a retest of the sample, then SemenView
will show a flashing Retest indicator and the digits will turn red in the result field.
Figure 19 The digits turns red and the Retest indicator will flash red if Retest of a
sample is suggested
In some cases the following is displayed in the result field:
Figure 20 No digits are shown – only red dashes, and the Retest indicator will flash red
if the instrument reports an error.
This occurs when the instrument displays: “Error: Sample could not be analysed. Press
any key” or if you have set the F32 – Retest res.? to "Off". (refer to User’s Guide for the
NucleoCounter SP-100 regarding further explanation).
4.3 DF – Dilution Factor
The dilution factor used by the NucleoCounter SP-100 during analysis is displayed in the
top right field.