ChemoMetec SP-100 - Manual (Page 25)

4 Analysis tab
15
4 Analysis tab
Analysis is the default start-up tab of SemenView. In this tab data and results
transferred from the NucleoCounter SP-100 are automatically displayed. An example of
the Analysis tab is shown in figure 18.
Once SemenView has been launched the Analysis tab is automatically displayed. Usually
there are no files in the active session upon start-up. Start the measurements or use the
Browse button to navigate to another session (see chapter 4.6 Folder selection.).
Figure 18 The SemenView Analysis tab.
When a result of a Semen analysis is received from the NucleoCounter SP-100, the
Cells/ml Sample, Image data, DF and Sample ID are displayed. The result from each
analysis is saved on the computers hard disk in an individual data file. The
NucleoCounter SP-100 generates the data file and SemenView adds no data.
4.1 Cells/ml Sample
The estimated number of Semen cells/ml Sample is displayed to the right of the Image
data field. The result is presented in the same manner as in the display window of the
NucleoCounter SP-100.