ChemoMetec SP-100 - Manual (Page 21)

2 Getting started with SemenView TM
11
2 Getting started with SemenView T M
SemenView allows the user to register the results of counting of cells in Semen samples
with the NucleoCounter SP-100 on a computer. This is useful when documentation of
results and data is needed.
2.1 Launch SemenView TM
SemenView can be activated through the Windows “Start” menu. First select
“SemenView” from the “Programs” submenu, and then select “SemenView”.
When SemenView is launched, both SemenView and the NC Receiver appear on the task
bar. The NC Receiver is an application, which must be active when receiving data from
the NucleoCounter SP-100. NC Receiver is launched automatically when SemenView is
launched.
Data from NucleoCounter SP-100 can only be transferred if the NC
Receiver is active, therefore it must not be closed.
2.2 Quit SemenView TM
To quit SemenView click the “Quit” button in the Analysis tab.
Figure 16 Quit button