Elektron Octatrack - Manual (Page 129)

THE MIDI SEQUENCER
117
Parameter values can then be set as usual by using the DATA ENTRY knobs. Disable the
parameters again by repeating the enabling procedure.
PB controls the pitch bend setting.
AT controls the after touch setting.
CC1-CC4 controls the values that should be sent for the CC commands specified in the
CTRL 1 SETUP page.
CTRL 1 SETUP
Here the CC commands whose values are controlled in the CTRL 1 MAIN page are
selected. When selecting a CC command in this menu the graphics of the parameter will
become inverted. This indicates the parameter value hasn’t been activated yet. Press the
corresponding knob or [ENTER/YES] to activate the parameter change.
CC1-CC4 specifies the CC commands that will be controlled on the CTRL 1 MAIN page.
By pressing [FUNCTION] + knob C-F MIDI CC LEARN mode is activated. The next CC
message sent to the MIDI autochannel or the MIDI channel of the active track will be
assigned to the selected parameter.
• MIDI CC LEARN mode is very handy when wanting to control for example the cut-
off parameter of an external synth. Initiate MIDI CC LEARN mode and turn the cut-
off knob of the synthesizer. Given the knob sends out a CC message to either the
auto channel or the MIDI channel assigned to the active track, the CC of the knob
will be automatically assigned to chosen CC 1-4 parameter.
CTRL 2 MAIN
Here the values of up to six assignable CC commands are set. The default value of the
parameters is OFF, meaning they are disabled and won’t send out any data. Holding
[FUNCTION] and pressing the DATA ENTRY knobs will enable them. Parameter values