Elektron Octatrack - Manual (Page 180)

Appendix B: EFFECTS REFERENCE B-15
DARK REVERB
The dark reverb provides lush, wide stereo reverberation with long decay times. It is good for adding a
spacey ambience to a sound.
DARK REVERB MAIN
TIME sets the decay time of the reverberated
signal.
SHVG affects the damping of the reverberated
signal above the shelving frequency set by the
SHVF parameter. At max value treble is
included in the reverberations, lowering the
value gradually dampens it.
SHVF controls the frequency of the shelving fil-
ter inside the reverberator. Together with the
SHVG parameter it can be used to dampen the
reverberated signal above a chosen frequency,
making the reverberation sound darker.
HP controls the cutoff frequency of the high
pass filter affecting the incoming signal.
LP controls the cutoff frequency of the low
pass filter affecting the incoming signal.
MIX adjusts the mix between the original dry
signal and the reverberated signal. When
MIXF of the DARK REVERB SETUP page is
set to SEND, the MIX parameter works simi-
larly to an aux send knob of a mixer.
DARK REVERB SETUP
PRE adjusts the length of a short delay before
the signal reaches the reverberator.
BAL sets the balance between the left/right
channel of the reverberated signal.
MONO continuously adjusts the width of the
reverberated signal from stereo to mono.
MIXF defines the functionality of the MIX con-
trol of the DARK REVERB MAIN page to be
either MIX or SEND.