Elektron Octatrack - Manual (Page 99)

PATTERNS
87
performing a track page copy operation, make sure you are in GRID RECORDING mode. If
not, press [REC].
Select the track containing the data you want to copy, then select the track page you want
to copy by pressing the [PATTERN PAGE] key. Hold the [PATTERN PAGE] key and press
[REC] to copy the track page. A message saying “COPY PAGE” page will appear. Select
the track page you want to paste the copied page to by pressing the [PATTERN PAGE]
key. Paste the data by holding [PATTERN PAGE] while pressing the [STOP] key. A mes-
sage saying “PASTE PAGE” will be shown in the display. Pasting a track page overwrites
any previous trigs, parameter locks, machine and effects assignments.
The paste track page operation can be undone by pressing [PATTERN PAGE] + [STOP].
The message “UNDO PAGE” will be shown in the display.
• The copied data can be pasted to another track. After having performed the track
page copy command, select the new track and, if needed, the track page. Then
paste.
TRACK PAGE CLEAR
It is possible to clear all trigs from a track page. Before performing a track page clear oper-
ation, make sure you are in GRID RECORDING mode. If not, press [REC].
Select the track page you want to clear by pressing the [PATTERN PAGE] key. Clear the
track by pressing [PATTERN PAGE] + [PLAY]. The message “CLEAR PAGE” will appear.
The clear track page operation can be undone by pressing [PATTERN PAGE] + [PLAY].
The message “UNDO PAGE” will be shown in the display.
TRACK PARAMETER PAGE COPY
The settings of the TRACK PARAMETER pages can be copied and pasted. The content of
both the MAIN and SETUP pages will be copied when performing this operation.
Select the TRACK PARAMETER page you wish to copy and press [TRACK PARAME-
TER] + [REC]. A message saying “COPY PAGE” will appear. Paste the copied content by
pressing [TRACK PARAMETER] + [STOP].
The TRACK PARAMETER page paste operation can be undone by pressing [TRACK
PARAMETER] + [STOP]. The message “UNDO PAGE” will be shown in the display.
TRACK PARAMETER PAGE CLEAR
A TRACK PARAMETER page can be initialized to its default settings.
Select the TRACK PARAMETER page you wish to clear and press [TRACK PARAME-
TER] + [PLAY]. A message saying “CLEAR PAGE” will appear. Undo the operation by
pressing [TRACK PARAMETER] + [PLAY] one more time.
TRIG COPY
It is possible to copy a trig of any type, complete with all parameter lock settings, and paste
it to a another sequencer step. First make sure you are in GRID RECORDING mode. If not,
press [REC].