Hardy HI 1756-nDF - Manual (Page 11)

7
●
●
●
●
●
Chapter 3
Chapter 3 Installation
● ● ● ● ●
Chapter 3 covers unpacking, cabling, interconnecting, configuring, and installing the
Weigh Scale Module. User and service personnel should read this chapter before
installing or operating the Weigh Scale module.
Unpacking
Step 1. Before signing the packing slip, inspect the packing and contents for damage of
any kind. Report any damage to the carrier company immediately.
Step 2. Verify that everything in the package matches the bill of lading.
Step 3. Write down the Model and Serial number of the module. Store this information
in a convenient location for reference when contacting The Customer Support
Department for parts or service.
Step 4. Be sure to complete the warranty registration on the Hardy web site.
Installing the HI 1756 nDF
Allen-Bradley ControlLogix Processor or Remote Rack
WARNING Electrostatic discharge may damage semiconductor components in the module. DO NOT
TOUCH THE CONNECTOR PINS, and observe the following handling precautions:
Wear an approved wrist-strap grounding device when handling the module.
Touch a grounded object or surface to rid yourself of any electrostatic
discharged prior to handling the module.
Handle the module from the bezel in front away from the connector. Do not
touch the connector pins.
Do not install the module right next to an AC or high voltage DC module.
Route all the load voltage cables away from high voltage cables.
A ControlLogix Chassis
Step 1. Make sure that the module is
oriented correctly for installation.
Step 2. Gently slide the module into the
Chassis.
Step 3. Slide the digital board between the
PCB Guides on the top plate and
bottom plate of the chassis to line up
the module connector with the
backplane connector
Inserting the module