AltiGen IP 805 - Manual (Page 18)

System Settings
14 IP 805 User Manual
System Settings
Network Settings
Setting Menu Path Description
MaxCS
Server
address
System > Server IP Sets the MaxCS server’s IP address.
Trunk Access
Code System >
Trk Access Code
Sets the digit required to enable a user to return
an outside call from the Call Log.
Hour Offset System > Hour Offset
Sets the time offset from the MaxCS server’s
time.
TFTP Server System > TFTP Server
Sets the TFTP server IP address for updating
firmware.
Boot
Download
System > Boot Download
After a firmware upgrade, this setting changes
to No. This is used mainly for upgrading or
troubleshooting. On the next boot, the IP phone
will download the new firmware from the TFTP
server, if this is set to Yes.
Emergency
Number
System > Emergency Num
Sets the IP phone’s emergency number. For
the U.S., the emergency number is 911.
Emergency
Gateway
System > Emergency GW
Sets the IP phone’s emergency gateway IP
address
SIP Register System > Enable SIP Registration
Enables SIP registration to the emergency
gateway
Auto-discover System > Auto Discover
Enables automatic discovery of the server IP
address via DHCP option 120
E911 LID System > E911 LID Sets the IP phone’s E911 Location ID
Version
Information
System > Version Info [Read only] Displays the version number of the IP phone.
Setting Menu Path Description
Enable DHCP Network > Enable DHCP
Sets whether Dynamic Host Configuration
Protocol (DHCP) is being used by the IP phone
to retrieve a new IP address upon boot up.
Local Address Network > Local Address
Sets the IP phone’s local address; shows only if
DHCP is disabled.
Network Mask Network > Network Mask
Sets the IP phone’s network mask; shows only
if DHCP is disabled.
Gateway Network > Gateway Sets the default Gateway IP address.
NAT Address Network > NAT Address Sets the NAT server’s public IP address.
Enable Vlan Network > VLan
Enables or disables VLAN usage.
Note: When you change this setting, the phone
will automatically reboot after you close the
menus.
Enable 802.1q Network > Enable 802.1q Define the 802.1q VLAN ID.
Enable 802.1p Network > Enable 802.1p Define the 802.1p prioritization value.