AltiGen IP 805 - Manual (Page 19)

Configuring the IP 805 Phone
IP 805 User Manual 15
Registration from the Phone’s Menu
Under normal circumstances, the IP 805 phone registers itself automatically. However, if registration failed for
some reason (for example, the server was not available), registration can be started again from the IP 805
phone’s menu:
1. Press the Menu button.
2. Scroll to REGISTER.
3. Press .
Configuring IP Settings
An IP address is a unique logical address that identifies each host computer on a TCP/IP network. An IP
address is a 32-bit number expressed as four decimal numbers from 0 to 255, separated by periods.
Use these guidelines when manually entering the IP settings:
• Ensure the default gateway IP address is on the same subnet as the host IP address. Check with your
system administrator.
• When entering IP addresses into the IP 805, use the * key to enter periods. For example, 209.120.12.8
would be input as 209*120*12*8.
Assigning a Local IP Address
To assign an IP address, use the following steps:
1. Ensure that DHCP is disabled.
2. Press the Menu button, scroll to Network, then press .
3. Scroll to LOCAL ADDRESS, and press .
4. Use the keys on the dial pad to enter a new IP address, using the * key to enter periods.
5. Press .
Assigning a TFTP Server
The default TFTP Server is set to 0.0.0.0.
To assign the TFTP server, use the following steps:
1. Press the Menu button.
2. Use  to select System, then press the button.
3. Scroll to TFTP Server, and press .
4. Use the keys on the dial pad to enter the new TFTP server address, using the * key to enter periods, then
press .
Updating Phone Firmware
To update the phone firmware directly from the IP 805 phone, follow these steps:
1. Press the Menu button.
2. Use the  button to scroll to System, then press .
3. Scroll to TFTP Server, then press .
4. Enter the TFTP server address, using the * key to input periods.
5. The IP 805 will download the firmware from the TFTP server on the next reboot.
6. Reboot by pressing * * 3 and .