Lcd messages, Local menu configuration messages, Ip phone running messages – AltiGen IP 805 User Manual

Page 31

Advertising
background image

Appendix A

IP 805 User Manual 27

LCD Messages

Local Menu Configuration Messages

The following messages may appear in the LCD screen when accessing the phone’s menu:

IP Phone Running Messages

The following messages may appear in the LCD screen while you use the phone:

Register failed

Check that the extension number and extension password are set up
properly and that the system administrator enabled the IP extension.

Ask the System administrator to confirm that the IP Phone Service is
started in MaxCS.

If an analog phone or other IP phone is already logged on to the same
extension, rebooting the IP 805 will not register the phone
successfully. You must press #27 on the IP phone to actively log on
to AltiServ. After the extension is logged on and activated, calls will
be redirected to this phone.

Message

Explanation

conf timeout!

After 2 minutes inside the configuration menu, if no action is taken, the LCD will
show this message and then close the menu.

conf exception!

During configuration, an unknown exception occurred.

Saved!

The changed configuration was saved.

Write Fail!

An error occurred when saving the changed options into flash ROM.

Wrong Ext Number!

The extension number that you entered is invalid.

Wrong input!

You entered an invalid value or string during configuration.

wrong password!

You entered an invalid password from the phone menu.

Message

Explanation

AW UNREACHABLE!

Failed to connect to the AltiGen phone server. You are trying to register the IP
phone with an invalid IP address, or the AltiGen Phone Server's IP address is
invalid.

The network connection has been lost in offhook or connect state.

Refer to “MaxCS is unreachable” section of “Troubleshooting” on page 25.

Basic-Idle

The phone is operating in Basic mode.

Press #27 again to reactivate.

Check the IP Phone Service.

Verify that the extension is configured for dynamic.

DHCP FAIL!

Although DHCP was enabled, the phone was not able to receive the IP address
from the DHCP server.

DUPLICATE IP!

Another device configured with the same IP address has been detected. The phone
cannot function correctly until this is corrected.

Problem/Symptom

Solution

Advertising