Brother WP330MDS - Manual (Page 21)

Precautions
Although this word processor is ruggedly constructed, it should not be exposed to
extreme conditions. To ensure many years of reliable operation, please follow these
recommendations;
WARNING:
To reduce the risk of electric shocks, do not attempt to disassemble the
unit. There is no user-serviceable parts inside. Some components inside
the unit use high voltages that can be of sufficient magnitude to constitute
a risk of electric shock to persons. Any servicing should be referred to
qualified service personnel.
• In case of malfunction, overheating, or other problems, immediately disconnect
the AC plug and consult your dealer.
• Do not attempt to disassemble the word processor. It has no user-serviceable
parts inside.
• Do not tug on the power cords or on the signal cable. To disconnect, be sure to
always grasp the plug Itself.
Avoid dropping the word processor.
Avoid direct exposure to sunlight and other sources of heat.
Avoid spills. If any liquid enters the word processor, immediately disconnect the
AC plug and consult your dealer.
Avoid locations subject to excessive moisture or dust.
Do not use sprays in the vicinity of the word processor. Aerosols are extremely
harmful to the disk drive.
Disconnect the AC plugs during thunderstorms.
Do not place heavy objects on the keyboard.
Always keep the air vents free from obstruction to avoid overheating the word
processor.
Clean with a soft, dry cloth only. Avoid using chemicals, solvents and detergents.
To avoid interference, do not place the word processor too close to a radio
receiver or television. If the word processor is too close to a television set, the
disk drive may not work properly. For the same reason, do not place the CRT
display too close to the word processor.
If you switch the word processor off, wait at least 10 seconds before switching it
on again. Failure to wait 10 seconds may disrupt the start-up sequence,
resulting in faulty operation and possible hardware damage.
11