Select the playback modes, 2 start dash & play, One-program repeat playback – Kenwood UD-952 User Manual
Page 33: Rewind playback, Dash & play
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Dash & play
/ Select the playback modes.
) Select the
MAIN INPUT key.
r~rV^
2 Start dash & play.
When a non-recorded space of more than 10 seconds is detected dur
ing playback, that space is automatically skipped by fast winding to
play only the tape sections where sound is recorded.
Each press of the key switches the modes as follows.
® "cto" ....The two tape sides are played 8 times, after which
playback stops.
(D "rrt" ....A tape side is played 8 times, after which playback
stops,
— (D “7=3"
....The two tape sides are played once, after which play
back stops.
• If "=>" is selected while tapes are present in both decks A and B,
Dash & Play of the second deck starts after Dash & Play of the first
selected deck has completed. This is repeated 16 times, after which
the playback stops.
I Main unit only I
Press simultaneously.
i When the ■ key is pressed, playback stops and the dash & play is
canceled.
One-program repeat playback
During playback of side
B (while is lit)
Press during playback,
(when side A is facing toward you)
• The program being played will be repeated 16 times, after which
normal playback resumes.
• When the ■ key is pressed, playback stops and the one-program
repeat is canceled.
Rewind playback
During playback of side A (while ► is lit]
I Main unit only I
Press simultaneously,
(when side A is facing toward you)
► Tape is rewound until the beginning of the program being played,
then its playback starts.