Kenwood UD-952 - Manual (Page 4)

Before operation
The marking of products using lasers
(Except for some areas)
I cuss, I
I LASER PRODUCT |
The label Is attached to the rear panel and says that the compo­
nent uses laser beams that have been classified as Class 1. It
means that the unit is utilizing laser beams that are of a weaker
class. There is no danger of hazardous radiation outside the unit.
Unit destination Shape of the AC outlet
U.S.A.,Canada
and U.S. Military o
U.K.
Australia o
Europe and
Other countries C3>
CAUTION:
Use of controls or adjustments or performance of proce­
dures other than those specified herein may result in
hazardous radiation exposure.
In compliance with Federal Regulations, following are
reproductions of iables on, or inside the product relating
to laser product safety.
r" KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI,
TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS NO. 21 CFR
1040. 10, CHAPTER I, SUBCHAPTER J.
Location: Back Panel
FM DE-EMPHASIS/CHANNEL SPACE switch (Except for some areas)
The FM DE-EMPHASIS/CHANNEL SPACE switch on the rear panel is set to
the correct setting that prevails in the area to which the unit is shipped.
However, if the FM DE-EMPHASIS/CHANNEL SPACE setting is not matched
to the area where the unit is to be used; for instance, when you move from
area 1 to area 2 or vice versa, desired reception of AM/FM broadcasts is not
expected. In this case, change the FM DE-EMPHASIS/CHANNEL SPACE
setting in accordance with the area corresponding to the table. The FM DE­
EMPHASIS is switched over at the same time.
• When changing the setting of the FM DE-EMPHASIS/CHANNEL SPACE
switch, first disconnect the power cord, then reset the channel space
switch, connect the power cord again, and turn the power on.
Area CHANNEL
SPACE freq.
FM
DE-EMPHASIS
1
U.S.A., Canada,
and South Ameri­
can countries
FM;100kHz
AM: 10kHz
75p,s
2 Other countries
FM: 50kHz
AM: 9kHz
50ps
DE-EMPHASIS
CHANNEL SPACE
O
1% iP I 75lis