Kenwood UD-952 - Manual (Page 8)

Connection method
© Push the lever. ® Insert cord. © Return the lever.
Connection of AM antenna
Connection of AM loop antenna
The provided antenna is for indoor use. Place it in a position as far as
possible from this system, TV, speaker cords and power cord and set
to the orientation which provides the best reception condition.
rO
Preamplifier/tuner unit C-E9
ii^ ^ ^ ^ ^
V
Connection of AM outdoor antenna
If the reception condition is poor with the loop antenna alone, connect
a vinyl coated wire of more than 6 m (20 ft) and extend it outdoors
while leaving the loop antenna connected.
Preamplifier/tuner unit C-E9
Connectiol) of FM entejjim
Connection of FM simplified antenna
The provided antenna is designed for temporary indoor use. For stable
reception, it is recommended to install an outdoor antenna as soon as
possible. Once an outdoor antenna is connected, remove the indoor
antenna.
Connection of FM outdoor antenna
Lead the antenna wire indoors using a 75 coaxial cable and connect
it to the FM 75 £2 connector.
® Remove the coating from the c(
section and twist conductors.
® Find the location providing the best
receiving condition.
(3) Fix the antenna there.
When a T-shaped, FM indoor antenna (300 £1) which is marketed in audio stores is used, connect
it to these terminals. (In this case, disconnect the provided FM simplified antenna.)
System connections
Do not plug the power cord into the power outlet until
all of the required connections have been made.
• When arranging the system units in a vertical, stacked configu­
ration, observe the stacking order indicated in the system con­
nection diagram below.
• In case an associated system component is connected, also
read the instruction manual of the component