Comtrol IO-Link Master EIP-4 - Manual (Page 69)

IO-Link Master EtherNet/IP Reference Manual: 2000589 Rev. A Chapter 4. IO-Link Port Configuration - 69
EtherNet/IP Settings Parameters
PDO Data Byte-Swap Method
Default: Word (16-bit) byte-swap
If enabled, the IO-Link Master swaps the data bytes in word (2 byte)
format or dword (4 byte) format. Supported values are:
• No byte-swap – data passed through as received
• Word (16-bit) byte-swap – data is byte-swapped in word format
• Dword (32-bit) byte-swap – data is byte-swapped in dword format
Note: The byte swapping must be set correctly in order to convert from
EtherNet/IP (little-endian byte order), to IO-Link (big-endian byte
order).
Clear Event Code in PDO Block
Default: False
If enabled, the IO-Link Master expects the first 2 bytes, word, or dword of
the PDO block to be used for event code handling. Supported values are:
• True = expect event code
• False = no event code, expect only PDO data
Clear Event Code After Hold
Time
Default: True
If enabled, the IO-Link Master clears any event code reported in the PDI
data block after the Event Active Hold Time. Supported values are:
• True = clear event code after hold time
• False = do not clear event code after hold time
Event Active Hold Time
Default: 1000 ms
If Clear Event Code After Hold time is enabled, the time period an event
code is reported in the PDI block before it is cleared.
• Valid range: 1-65535
• Valid Units:
- ms (milliseconds)
- sec (seconds)
- min (minutes)
- hours
- days
Clear Event Hold Time
Default: 500 ms
Once an event code has been cleared, the time an event code stays cleared
in the PDI block before another event code can be reported.
• Valid range: 1-65535
• Valid Units:
- ms (milliseconds)
- sec (seconds)
- min (minutes)
- hours
- days
EtherNet/IP Settings Page (Continued)