Global configuration mode – Comtrol ES8508 Series User Guide User Manual
Page 141
RocketLinx ES8508 Series User Guide: 2000575 Rev. A
Global Configuration Mode - 141
Configuration Using the Command Line Interface (CLI)
Global Configuration Mode
If you type configure terminal in Privileged EXEC mode, you can then access Global Configuration mode. In
Global Configuration mode, you can configure all ES8508 features. Type the following commands and press
the Enter key:
•
interface IFNAME/VLAN, to access the corresponding Interface Configuration mode.
•
exit to return to Privileged EXEC mode.
•
? to see the command list.
•
list to review the Global Configuration mode commands and corresponding options.
The following is a list of available command lists of Global Configuration mode. For the complete list of
commands and options, refer to
Switch# configure terminal
Switch(config)#
administrator Administrator account setting
arp Set a static ARP entry
clock Configure time-of-day clock
default Set a command to its defaults
dot1x IEEE 802.1x standard access security control
end End current mode and change to enable mode
ethertype Ethertype
exit Exit current mode and down to previous mode
gmrp GMRP protocol
gvrp GARP VLAN Registration Protocol
hostname Set system's network name
interface Select an interface to configure
ip IP information
ipv6 IP information
lacp Link Aggregation Control Protocol
list Print command list
lldp Link Layer Discovery Protocol
log Logging control
loop-protect Ethernet loop protection
mac-address-table Mac address table
mirror Port mirroring
modbus Modbus TCP slave
nameserver DNS Server
netvision NetVision protocol
no Negate a command or set its defaults
ntp Configure NTP
ptpd IEEE1588 Precision Time Protocol
qos Quality of Service (QoS)
redundant-ring Configure redundant ring
router Enable a routing process
service System service
smtp-server SMTP server configuration
snmp-server SNMP server
spanning-tree spanning tree algorithm
trunk Trunk group configuration
vlan Virtual LAN
warning-event Warning event selection
write-config Specify config files to write to