Comtrol ES8508 Series User Guide - Manual (Page 181)

RocketLinx ES8508 Series User Guide: 2000575 Rev. A Warnings (CLI) - 181
Configuration Using the Command Line Interface (CLI)
Fault Relay Output (cont.)
Display
Switch# show warning-event
Warning Event:
Cold Start: Enabled
Warm Start: Disabled
Authentication Failure: Disabled
Link Down: fa4-5
Link Up: fa4-5
Power Failure:
Ring: Disabled
Fault Relay: Disabled
Time synchronize Failure: Disabled
DI: Disabled
Syslog Configuration
Local Mode Switch(config)# log syslog local
Server Mode
Switch(config)# log syslog remote
192.168.250.33
Both
Switch(config)# log syslog local
Switch(config)# log syslog remote 192.168.250.33
Disable Switch(config)# no log syslog local
SMTP Configuration
SMTP Enable
Switch(config)# smtp-server enable email-alert
SMTP Email Alert set enable ok.
Sender mail
Switch(config)# smtp-server server 192.168.250.100
ACCOUNT SMTP server mail account, ex: [email protected]
Switch(config)# smtp-server server 192.168.250.100
[email protected]
SMTP Email Alert set Server: 192.168.250.100, Account:
[email protected] ok.
Receiver mail
Switch(config)# smtp-server receipt 1 [email protected]
SMTP Email Alert set receipt 1: [email protected] ok.
Authentication with
user name and
password
Switch(config)# smtp-server authentication username admin
password admin
SMTP Email Alert set authentication Username: admin,
Password: admin
Note: You can assign string to user name and password.
Disable SMTP
Switch(config)# no smtp-server enable email-alert
SMTP Email Alert set disable ok.
Disable Authentication
Switch(config)# no smtp-server authentication
SMTP Email Alert set Authentication disable ok.