Comtrol ES8508 Series User Guide - Manual (Page 49)

RocketLinx ES8508 Series User Guide: 2000575 Rev. A Basic Settings - 49
Configuration Using the Web Interface
Basic Settings
The Basic Setting group allows you the ability to configure switch information, IP address, User name/
Password of the system. It also allows you to do firmware upgrade, backup and restore configuration, reload
factory default, and reboot the system.
The following web pages are included in this group:
• Switch Setting on Page 49
• Admin Password on Page 50
• IP Configuration on Page 51
• Time Setting on Page 53
• DHCP Server Configuration on Page 56
• Backup and Restore on Page 61
• Firmware Upgrade on Page 67
• Factory Defaults on Page 69
• System Reboot on Page 69
Note: This User Guide refers to all three models as the ES8508 unless there is
information specific between the models.
Optionally, you can use the CLI for configuration, see Basic Settings (CLI) on Page 146.
Switch Setting
You can assign the System Name, Location, Contact and view ES8508 information.
Switch Setting Page
System Name
You can assign a name to the ES8508. You can input up to 64 characters. After you
configure the name, The CLI system selects the first 12 characters as the name in
CLI system.
System Location You can specify the ES8508 physical location with up to 64 characters.
System Contact
You can specify contact people with up to 64 characters by typing the Administer’s
name, mail address or other information.
ES8508F and ES8508F-XT:
System Description displays as RocketLinx ES8508F
Industrial Managed Ethernet Switch. The MAC address
is 00 C0 4E 3C xx xx. and the System OID is unique.