Comtrol ES8508 Series User Guide - Manual (Page 180)

180 - Warnings (CLI) RocketLinx ES8508 Series User Guide: 2000575 Rev. A
Configuration Using the Command Line Interface (CLI)
Warnings (CLI)
The ES8508 provides several types of warning features for you to remotely monitor the status of the attached
devices or changes in your network. The features include Fault Relay, System Log and SMTP Email Alert.
Optionally, you can use the web user interface for configuration, see Warning on Page 116.
This table provides detailed information about the command lines of the warning configuration.
Fault Relay Output
Relay Output
Switch(config)# relay 1
di DI State
dry dry output
ping ping failure
port port link failure
power power failure
Note: ring super ring failure
DI State
Switch(config)# relay 1 di
1 DI number
Switch(config)# relay 1 di 1
high high is abnormal
low low is abnormal
Switch(config)# relay 1 di 1 high
Dry Output
Switch(config)# relay 1 dry
<0-65535> turn on period in second
Switch(config)# relay 1 dry 5
<0-65535> turn off period in second
Switch(config)# relay 1 dry 5 5
Event Selection
Switch(config)# warning-event
coldstart Switch cold start event
warmstart Switch warm start event
linkdown Switch link down event
linkup Switch link up event
authentication Authentication failure event
di Switch di event
fault-relay Switch fault relay event
loop-protect Switch loop protection event
power Switch power failure event
ring Switch ring event
time-sync Switch time synchronize event
Example:
Cold Start event
Switch(config)# warning-event coldstart
Set cold start event enable ok.
Example:
Link Up event
Switch(config)# warning-event linkup
[IFNAME] Interface list, ex: fa1,fa3-5
Switch(config)# warning-event linkup fa1
Set fa5 link up event enable ok.