Roland VS-890 - Manual (Page 29)

Algorithm List
EQ (Equalizer)
EQ (Switch) On, Off Turns the equalizer on or off.
LowType (Low Type) Shiv, Peak Sets the type of the low frequency band equalizer
(Shlving type or peaking type).
Low.G (Low Gain) -12-+12dB Sets the boost/cut amount in the low frequency band.
Low.F (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low.Q (Low Q) 0.3-10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings.1 *2
Mid.G (Middle Gain) -12-+12dB Sets the boost/cut amount in the middle frequency band.
Mid.F (Middle Frequency) 200-8000 Hz Sets the center frequency in the middle frequency band.
Mid.Q (Middle Q) 0.3-10.0 Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Hi Type (High Type) Shiv, Peak Sets the type of the high frequency band equalizer (Shlving
type or peaking type).
Hi.G (High Gain) -12-+12dB Sets the boost/cut amount in the high frequency band.
Hi.F (High Frequency) 1.4-20.0 kHz Sets the center frequency in the high frequency band.
Hi.Q (High Q) 0.3-10.0 Sets the width of the area around the high frequency that
will be affected by the gain settings.1 *2
Out Level (Output Level) 0-100 Sets the volume after passing through the equalizer.
*1; The sum of the Delay Time (Time) value and the Delay Shift (Shift) value should not exceed the setting range of
Delay Time. For example, if Delay Time is set to 1000 ms, the setting range of Delay Shift is L200 to R200 ms.
*2: If Low Type (LowType) or Hi Type (High Type) is set to "Shiv (Shlving Type)," the setting for LowQ or High Q
is invalid.
29