Roland VS-890 - Manual (Page 40)

Algorithm List
Parameter (full name) Setting Function
CMP (Compressor):Compresses the entire output signals when the input volume exceeds a specified value.
Comp (Switch) On, Off Turns the compressor on or off.________________________
Attack (Attack) 0-100 Sets the strength of attack whan a sound is input.
Level (Level) 0-100 Sets the volume of the compressor sound.
Sustain (Sustain) 0-100 Sets the time over which low level signals are boosted to a
constant volume.
Tone (Tone) -50-50 Sets the tone color.
MTL (Heavy Metal) / DST (Distortion) / ODV (Overdrive): Gives distortion to the sound.
(Switch) On, Off Turns the metal, distortion or overdrive on or off.
Gain (Gain) 0-100 Sets the degree of the distortion.
Level (Level) 0-100 Sets the volume of the metal, distortion or overdrive sound.
HiGain (High Gain) - 100-100 Sets the boost/cut amount in the high frequency band,
(only for Metal)
______ _________________
MidGain (Middle Gain) - 100-100 Sets the boost/cut amount in the middle frequency band,
(only for Metal)
____
LowGain (Low Gain) - 100-100 Sets the boost/cut amount in the low frequency band,
(only for Metal)
Tone (Tone) 0-100 Sets the tone color, (for Distortion/Overdrive only)
NS (Noise Suppressor):
NoiseSup (Switch)
Mutes noise in the silent mode.
On, Off Turns »le noise suppressor on or off.
Thresh (Threshold) 0-100 Sets the level to start muting noise.
Release (Release) 0-100 Sets the time over which the volume will drop to 0 after the
noise starts being muted.
WAH (Auto Wah):
Wah (Switch)
Adds the wah effect.
On, Off Turns the auto wah on or off.
Mode (Mode) LPF, BPF Set to “BPP for the wah effect in a narrow range of
frequencies and to “LPP for wah effect in a broad range of
frequencies.
Pol (Polarity) Up, Down Activated only for adding the wah effect according to input
volume changes. Set to “Up" for moving the filter to a higher
frequency and "Down” for moving it to a lower frequency.
Freq (Frequency) 0-100 Sets the frequency at which the wah effect starts working.
Level (Level) 0-100 Sets the volume of the wah sound.
Peak (Peak) 0-100 Sets the degree of the wah effect applied at around the
frequency.
Sens (Sense)
0-100
Normally “0.”
Sets sensitivity for input volume changes for adding the
wah effect according to input volume changes.
Rate (Rate) 0.1-10.0 Hz Sets the rate at which the wah effect will be cyclically modulated.
Depth (Depth)
0-100
Sets the depth at which the wah effect will be cyclically modulated.
AMP (Guitar Amplifier Simulator): Simulates Guitar Amplifier.
G.AmpSIm (Switch) On, Off Turns the guitar amplifier simulator on or off.
Mode (Mode) See the column on
the previous page.
Type of the guitar amplifier.
40