Roland VS-890 - Manual (Page 56)

Algorithm List
Stereo Multi
Parameter (full name) Setting Function
NS (Noise Suppressor):
NoiseSup (Switch)
Mutes noise in the silent mode.
On, Oft Turns the noise suppressor on or off.
Thresh (Threshold) 0-100 Sets the level to start muting noise.
Release (Release) 0-100 Sets the time over which the volume will drop to 0 after the
noise starts being muted.
CL (Compressor/Limiter): Compresses the entire output signals when the input volume exceeds a
specified value.
Comp/Lim (Switch) On, Off Turns the compressor on or off.
Level (Output Level) -60-12 dB Sets the volume of the compressor sound.
Thrsh (Threshold Level) -60-0 dB Sets the level at which the compressor starts taking effect.
Attack (Attack Time) 0-100 Sets the time from when the input level exceeds the
threshold level to when the effect begins to apply.
Release (Release Time) 0-100 Sets the time from when the input level drops below the
threshold level to when the effect ceases to apply.
Ratio (Ratio) 1-5:1,2:1,4:1,100:1 Sets the compression ratio applied when the threshold level
is exceeded.
ENH (Enhancer): Accentuates the sound and push the sound forward.
Enhancer (Switch) On, Off Turns the enhancer on or off.
Sens(Sense) 0-100 Sets the degree of the enhancer effect desired.
Freq (Frequency) 1.0-10.0 kHz Sets the frequency at which the enhancer effect starts
working.
MixLvl (Mix Level) 0-100 Sets the amount of the enhancer sound should be mixed
into the direct sound.
Level (Level) 0-100 Sets the volume of the enhancer sound.
56