Roland VS-890 - Manual (Page 69)

Algorithm List
Parameter (full name) Setting Function
VOC2 (Vocoder):
Env (Envelope)
The pitch is specified as in the instrumental sound while the tone is output in
the human voice.
Sharp, Soft, Long Defines characteristics of the sound.
Pan (Pan Mode) Mono, Stereo Defines how the sound is located.
Hold (Hold) Off, MIDI Specifies that an instrumental sound is or is not issued with
the formant Axed.
MicSens (Microphone Sensitivity) 0-100 Sets the input sensitivity of the microphone.
SynInLev (Synthesizer In Level) 0-100 Sets the input level of the instrumental sound.
V.Char 1 - 1 9
(Voice Character Channels 1 - 1 9 )
0-100 Sets the tone of the vocoder.
MHPF (Microphone HPF) Thru, 1.0-20.0 kHz Sets the frequency at which HPF on the vocal sounds
through the microphone starts taking effect.
Sets this to Thru” it HPF is not desired.
MHPFPan (Microphone Pan) L6S-R63 Sets the panning of vocal sounds through the microphone.
MicMix (Microphone Mix) 0-100 Sets the amount of the sound after passing through the
microphone HPF should be mixed into the Vocoder output.
NSThresh (Noise Suppressor Threshold) 0-100 Sets the volume to start muting noise on the instrumental
sound input
ïhorus): Adds spaciousness and depth to the sound.
Chonjs (Switch) On, Off Turns the chorus on or off.
Rate (Rate) 0.1-10.0 Hz Sets the rate of modulation.
Depth (Depth) 0-100 Sets the depth of modulation.
PreDLY (Pre-Delay) 0-50 ms Sets the time delay from when the direct sound begins until
the choais sound is heard.
MixBal (Mix Balance) 0-100 Sets the volume balance between the chorus sound and
the direct sound.
69