Haltech E6GMX - Manual (Page 28)

E6GMX Manual
28
MAP Sensor
The ECU needs to know the type of Manifold Absolute Pressure (MAP) sensor being
used. If you do not know what sensor you have refer to Error! Reference source not
found. Error! Reference source not found., pError! Bookmark not defined.. Enter
the correct description here to match. If using throttle position mode, set this
parameter to a 1 Bar sensor.
RPM Limit
The ECU can limit the maximum rpm at which the engine will operate. Above this
level the ECU completely cuts fuel or ignition (see below) to the engine. When the
engine speed drops below the RPM Limit the E6GMX will resume normal fuel or
ignition delivery. This is known as hard limiting. If the RPM Limit is not needed then
set this value above the highest operating point of the engine.
Road Speed Value
This value calibrates the Road Speed reading. The value represents the number of
pulses received from the road-speed sensor over a distance of 1 km.
RPM Limit Type
The RPM Limit can either be a fuel cut or an ignition cut. This field determines what
form of limit will be used. Be careful using an ignition cut since the unburnt fuel can
damage the catalytic converter.
Units
The programming software can display parameters in either Metric or US units. At
present HalwinX is fixed to SI units.
RPM Mode
The ECU fuel and ignition maps may be arranged either in 500 rpm increments from 0
rpm to 10,500 rpm, or in 1000 rpm increments from 0 rpm to 16,000 rpm. Select the
high or low rpm mode here. Changing this setting alters the way the ECU reads the
fuel and ignition Maps, and will change the tuning of the engine dramatically.
Dual Map Setup
This allows the user to switch between Fuel and Ignition map 1 and Fuel Ignition map
2. If Dual Map disable is selected, Fuel and Ignition map 1 is selected.
Use of Secondary Map
This defines the method by which the ECU determines which base map to use. The
options are:
Never
This causes the ECU to only use the primary base fuel and
ignition maps.
Always This causes the ECU to only use the secondary base fuel
and ignition maps.
Enable with Aux. In This causes the ECU to use the primary base fuel and
ignition maps when the Aux. In is not connected to ground.
The ECU uses the secondary base fuel and ignition maps
when the Aux. In is connected to ground.