Interlogix NVR 50 User Manual - Manual (Page 106)

11BChapter 12: Network settings
100 TruVision NVR 50 User Manual
Option Description
Working mode The NVR has two 10M/100M/1000M NIC cards that support net
fault tolerance, load balance, and multi-address modes. Select
one of the options:
Net fault tolerance: When one LAN port fails, the other one
takes over. This is the default option.
Load balance: The bandwidth is divided over the two LAN ports
with one IP address.
Multi-address: Each LAN port is separate with its own IP
address. This allows one LAN port for the IOP cameras and the
other for client PCs such as TruNav.
Select NIC Select which LAN port is being defined.
NIC type Network interface card (NIC) is a device used to connect the
NVR to a network. Select the NIC type used from the drop-down
list.
Default value is 10/100/1000M self-adaptive.
Enable DHCP Check this box if you have a DHCP server running and want
your NVR to automatically obtain an IP address and other
network settings from that server.
Default value is Enable.
IPv4 address Enter the IP address for the NVR.
Default value is 192.168.1.82.
IPv4 subnet mask Enter the subnet mask for your network so the NVR will be
recognized within the network.
Default value is 255.255.255.0
IPv4 default gateway Enter the IP address of your network gateway so the NVR will
be recognized within the network. This is typically the IP address
of your router.
Default value is 192.168.1.1
IPv6 address 1 Enter the IPv6 address for the NVR.
Default value is fe80::240:30ff:fe48:2975/64.
IPv6 address 2 Enter the IPv6 address for the NVR.
IPv6 default gateway Enter the IPv6 address of your network gateway so the NVR will
be recognized within the network. This is typically the IP address
of your router.
MAC address Enter the MAC address.
MTU (bytes) Enter a value between 500 and 9676. Default is 1500.
Preferred DNS server Enter the preferred domain name server to use with the NVR.
Alternate DNS server Enter the alternate domain name server to use with the NVR.
Main NIC
(or Default route)
Select the main LAN port when net fault tolerance or load
balance mode is selected. LAN I is default.
Select which LAN is the main route when multi-address mode is
selected.
3. Click Apply to save the settings.