Interlogix NVR 50 User Manual - Manual (Page 97)

TruVision NVR 50 User Manual 91
Chapter 11
Alarm settings
This chapter describes setting up how the system will respond when an alarm is
triggered.
Description of alarm notification types
When setting up the rules for alarm detection, you can specify how you want the
NVR to notify you about an alarm or event. You can select more than one
notification type. Not all notifications types are available for all types of alarms.
The alarm notification types are:
• Audible warning: Triggers an audible beep when a notification or alarm is
detected.
• Notify surveillance center: Sends a signal to TruVision Navigator or other
software applications when an alarm or notification is detected.
• Trigger alarm output: Triggers an alarm output when a notification is
detected for an external alarm. See “Setting up external alarms” on page 94
for information on configuring an alarm output.
• Send e-mail: Sends an e-mail when an alarm or notification is detected. See
“Configuring e-mail” on page 103 for information on how to configure the NVR
to send an e-mail.
• Full screen monitoring: When an alarm is triggered, the local spot monitor
(VGA or BNC monitor) displays an image in live view mode. For alarms that
are triggered simultaneously, images display one at a time every 10 seconds
(default dwell time). You can set a different dwell time using the Dwell Time
setting under the Display Settings>Layout screen. When the alarm stops,
cycling of the images stops and you return to live view mode. This alarm
option must be selected for each channel where it is required..
This alarm notification is not available for system alarms.