Interlogix NVR 50 User Manual - Manual (Page 28)

3BChapter 4: Operating instructions
22 TruVision NVR 50 User Manual
Item Description
12. Preset Enter preprogrammed three-digit code to call up a preset.
13. Tour Enter preprogrammed three-digit code to call up shadow tour.
14. Focus + and - Use to control focus of camera lens.
15. Playback control Use to control playback (Rewind, Pause, Play, and Fast Forward).
16. Search Open the Search menu.
17. Replay Replay the selected file from the beginning.
18. Eject Eject the CD or DVD disk.
19. Archive Press once to enter quick archive mode. Press twice to start archiving.
Aim the remote control at the IR receiver located at the front of the unit to test
operation.
To connect the remote control to the TVN 50:
1. Press the Menu button on the front panel or right-click the mouse and select
the Menu button. The main menu screen appears.
2. Click Display Mode Settings > Monitor .
3. Check the device address value. The default value is 255. This device
address is valid for all IR controls.
4. On the remote control press the Device button.
5. Enter the device address value. It must be the same as that on the TVN 50.
6. Press OK on the remote control.
To place batteries into the IR remote control:
1. Remove the battery cover.
2.
Insert the batteries. Make sure that the positive (+) and negative (−) poles are
correctly placed.
3. Replace the battery cover.
Troubleshooting the remote control:
If the IR remote control is not functioning properly, perform the following tests:
• Check the battery polarity.
• Check the remaining charge in the batteries.
• Check that the IR remote control sensor is not masked.
If the problem still exists, please contact your administrator.