Canon DR-X10C - Manual (Page 123)

8-17
Chapter 8 ISIS/TWAIN Driver Settings
Color drop-out
These selections are enabled for scanning modes other
than 24-bit Color, so that you can select a primary color
(red, green, blue) or gray to be ignored (dropped out) or
enhanced.
The [Setting] buttons are enabled when [Drop-out color
Custom] or [Custom Color Enhance] is selected, so that
you can specify a color range in the [Color Settings] dialog
box for drop-out or enhancement.
Hint
• The color range within the shaded (cross-hatched) area is
dropped out or enhanced.
• You can move the shaded area by dragging with the mouse.
• You can change the specified color range by dragging the
edges of the shaded area.
• Because your operating environment affects the colors you
specify on screen, they may not match those actually dropped
out or enhanced: that is, the colors you specify may not match
those processed.
[Others] Tab Sheet
The settings on the [Others] tab sheet are different for the ISIS
and TWAIN drivers. Also, some settings may be disabled,
depending on the mode settings on the [Basic] tab sheet. For
details,
see “Mode-Dependent Function Limitations” on
p. 8-10 .
Hint
[Batch Separation] and [Patchcode Orientation] are functions for
setting the ISIS driver, so they are not displayed for the TWAIN
driver.
■ [Others] Tab Sheet Settings
You can configure the following settings on the [Others]
tab sheet.
[Rapid Recovery System] Check Box
If a paper jam causes paper transport to stop while
scanning, scanning stops without sending an error
notification to the application program. After fixing the
cause of the stoppage, you can continue scanning.