Canon DR-X10C - Manual (Page 27)

2-7
Chapter 2 Setup
3. Use the supplied USB cable to connect the scanner
to the computer.
Connect the square plug (Type B) of the USB cable to the
scanner.
■ Using a SCSI Connection
IMPORTANT
Make sure that the computer is turned OFF before connecting
the SCSI cable. If the cable is connected while the computer is
on, the scanner may not be properly recognized by the
computer.
1. Shut down Windows and turn the computer’s power
OFF.
2. Connect the supplied power cord into the power
connector on the back of the scanner. a
3. Connect the power cord into an AC outlet. b
4. Use the SCSI cable to connect the scanner to the
computer.
120 V Type
220 - 240 V Type