Canon DR-X10C - Manual (Page 128)

8-22
Chapter 8 ISIS/TWAIN Driver Settings
[Enable Barcode Detection] Check Box
Select this check box to detect barcodes in scanned
documents.
Hint
• Barcode detection only applies to barcodes within the
scanning area.
• To detect only certain barcodes when scanning documents
with multiple barcodes, you can set the detection area with the
barcode area setting.
[Search Side]
Select the side(s) of the document on which to detect
barcodes.
[Search Front]
Detect barcodes on the front side of documents.
[Search Back]
Detect barcodes on the back side of documents.
[Barcodes per Page]
Sets the number of barcodes (1 to 4) to detect per page.
[Orientation]
Set the orientation of the barcodes to detect.
Hint
Barcodes that scan perpendicular to the feeding direction have
0-degree orientation, and those that scan parallel to the feeding
direction have 90-degree orientation, and detection is possible
regardless of which end is the starting point.
Search Area
[Enable] check box
Select this check box to limit barcode detection to within a
specified area of the document, and then enter the start
positions and end positions for the horizontal direction and
vertical direction.
Hint
• When specifying an area on the front side of documents, the
x-offset is the distance from the left side of the feeder inlet
(viewed from the feeding direction).
• When specifying an area on the back side of documents, the
x-offset is the distance from the right side of the feeder inlet
(viewed from the feeding direction).
• The y-offset is the distance from the top of the page.
EAN
Detect EAN barcodes.
[Enable]
Detect and read EAN barcodes.
[Addon]
Set how to handle addon codes included in barcodes.
Off: Ignore addon codes.
On: Read addon codes.
Auto: Detect and read addon codes automatically.
Feeding
Direction 0 degrees 90 degrees