KGUARD Security AR 1621-2CKT001 - Manual (Page 38)

ENGLISH
Aurora Series: Configuring DVR Settings
38
DVR User’s Manual
Record Setup
Basic
Set the audio function and recording
mode for each channel.
Enable: Check to enable or uncheck
to disable the record mode for a
channel.
Audio: Check to enable the audio
recording for a channel. Uncheck to
disable this option.
Note:
This function requires a camera
with the audio support or an
external microphone.
Mode: Select the type of recording mode. There are two types of recording modes available: Always and Schedule.
Always: The DVR will continuously record for any period where Always mode is selected.
Note:
Make sure the space on hard disk is sufficient when using constant recording.
Schedule: The recording is performed according to a pre-defined schedule. To define the schedule. see “Schedule” on
page 39.
Copy CH/To CH: Copy the current settings to all channels or one specific channel. Click the arrow to select an option
and then click Copy.
After all settings are complete, click Apply.
Bit rate
The bit rate section allows you to
configure the actual amount of data
that the DVR will use to record a
video. The parameters that can be
configured is video resolution, frame
rate, and quality settings for each
channel.
Resolution: The two types of record
modes are as follows: D1 (CIF/HD1/
D1); 960H (WCIF/WHD1/WD1). The
resolutions CIF, WCIF, WD1 (960H)
can be selected only to channel 5 or
higher channel.