KGUARD Security AR 1621-2CKT001 - Manual (Page 44)

ENGLISH
Aurora Series: Configuring DVR Settings
44
DVR User’s Manual
• Motion Schedule Setup
Prior defining the motion schedule,
make sure the channel you want to
associate it with is Enabled.
In Schedule, click Settings and double-
click the time slot to set the schedule.
Start time/End time: Enter the Start
time and End time information when
the motion detection begins and ends.
To add additional schedule, click Add.
To disable motion detection at the
scheduled time, check the desired
schedule box that you want to delete
and click Delete.
Copy/To: Copy the current settings to other days. Click the arrow to select an option and then click Copy.
Click OK to save the settings.
• Motion Trigger Settings
About Motion Detection
In general, the motion detection can be used with almost all static and wired cameras. However, PTZ systems are
incompatible with motion detection, avoid allowing motion detection on a channel which has a PTZ system connected
to it.
False Triggers
It is very important to set the motion detection on a suitable sensitivity level. If you set the motion detection at a high
sensitivity levels (4 or lower) then the frequency of false alarm events increases. Vice versa if the sensitivity level is too
low (20 or higher), you might increase the risk that an important motion event will not trigger the motion detection to
record. Therefore during the DVR system configuration, it is advised to check the motion detection in normal and low
light conditions (during the day and night).
Also, false triggers may be caused by severe weather conditions, for example lightening and heavy rain. To minimize
the false triggers, do the following:
• Adjust the Image Settings to configure the brightness and contrast, see “Color Settings” on page 35.
• Make limitations to the motion sensitive areas, selecting only the area where the target would most probably be.
Hence, turn off the motion sensitivity to any area a target cannot move.
In Trigger, click Settings to configure
the actions to be taken when motion
is detected.
Record: Check the box to select the
channel(s) to record when the motion
is detected.
Snapshot: Check the box to select the
channel(s) to take a snapshot when
the motion is detected.
Send E-MAIL: Check to enable e-mail
alarm notification. If the function is
enabled, the system will send the
alarm messages / snapshots (snapshot
option must be enabled first) to the
specified e-mail address.