KGUARD Security AR 1621-2CKT001 - Manual (Page 45)

ENGLISH
Aurora Series: Configuring DVR Settings
DVR User’s Manual
45
Note:
Be sure to complete the E-mail and DNS server settings before enabling this function.
Alarm output: If an alarm device is connected, check the box to make the device sound the alarm when motion is
detected.
Push: Check the box to enable Push Event function on Mobile/Pad when the motion is detected.
Note:
To use Push Event function, you need to do the following:
- Enable MyKguard in DVR (see “MyKguard” on page 51 ).
- Configure the DVR network connection parameters.
- Download KView QR on your smart phone/pad. If you are using an iOS portable device, you need to enable
the Push Event function on app too.
Alarm output duration: Select the alarm sound duration of the I/O alarm device.
Buzzer: Set the buzzer duration when the motion is detected.
Pop-up screen: Select the corresponding channel will be displayed in full screen when the motion is detected.
Pre record: Set the recording period in seconds just before the motion triggers recording.
Post record: Set the recording period in seconds after the motion triggered recording has finished.
P.T.Z: Check the box to activate cruise of the PTZ camera on the specified channel when the motion is detected.
Click OK to save the settings.
Sensor
Customize the sensor settings.
Enable: Click to enable sensor alarm.
Type: Select the sensor type between
N/O (Normal Open) and N/C (Normal
Close).
Please check the documentation of
sensors to learn the correct value to
use.
Name: Specify the sensor name.
Schedule: Set the sensor detection
schedule. See
“Sensor Schedule
Setup” on page 46 .
Trigger: Configure the actions to be taken when sensor is triggered. See “Sensor Trigger Settings” on page 46 .
Copy CH/To CH: Copy the current settings to all channels or one specific channel. Click the arrow to select an option
and then click Copy.
After all settings are complete, click Apply.