KGUARD Security AR 1621-2CKT001 - Manual (Page 50)

ENGLISH
Aurora Series: Configuring DVR Settings
50
DVR User’s Manual
PPPoE
Select if you are using PPPoE
connection. With PPPoE (Point-to-
Point Protocol over Ethernet), your
DVR is most likely connected to a DSL
modem, and your ISP has supplied
you with an authentication user name
and password to the Internet.
PPPoE: Select Enable to use PPPoE
network connection.
User name: Enter the user name that
your ISP has supplied you.
Password: Enter the password that
your ISP has supplied you.
After all settings are complete, click Apply.
Port
Specify the Media Port and Web Port
numbers.
Media port: Is used to access your
DVR via portable device. The default
port number is 9000.
Web port: Is used to access your DVR
from your local LAN or the Internet
using a laptop or PC. The default port
number is 80.
After all settings are complete, click
Apply.
Note:
If you cannot use the either of the two default ports, 80 or 9000, the specified port may be occupied by other
programs or it is being blocked by your service provider. Enter other port number. In this case, you need to add
the port number after the IP address. For example, if you set the Web port as 85, you need to enter the IP address
as “192.168.3.103:85”.