KGUARD Security AR 1621-2CKT001 - Manual (Page 47)

ENGLISH
Aurora Series: Configuring DVR Settings
DVR User’s Manual
47
Note:
Be sure to complete the E-mail and DNS server settings before enabling this function.
Alarm output: If an alarm device is connected, check the box to make the device sound the sensor when triggered.
Push: Check the box to enable Push Event function on Mobile/Pad when the sensor is triggered.
Note:
• To use Push Event function, you need to do the following:
- Enable MyKguard in DVR (see “MyKguard” on page 51 ).
- Configure the DVR network connection parameters.
- Download KView QR on your smart phone/pad. If you are using an iOS portable device, you need to enable
the Push Event function on app too.
Alarm output duration: Select the alarm sound duration of the alarm device.
Buzzer: Set the buzzer duration when the sensor is triggered.
Pop-up screen: Select the corresponding channel will be displayed in full screen when the sensor is triggered.
Pre record: Set the recording period in seconds just before the alarm sensor input (before the alarm sensor triggers
the recording).
Post record: Set the recording period in seconds after the alarm sensor input (after the alarm sensor triggered
recording has finished).
P.T.Z: Check the box to activate cruise of the PTZ camera on the specified channel when the sensor is triggered.
Click OK to save the settings.
Video Loss
Video loss is regarded as a potential
alarm event, and is considered to
occur any time that the DVR does not
receive an active signal on any of its
inputs.
The default behavior of the DVR,
when a channel has no incoming
video signal, is simply to display
“Video Loss” in light blue text on a
black background over the associated
channel. If you’re not using all the
inputs on your DVR, then some
channels will be in constant Video
Loss state. Make sure that you don’t
Enable a video loss action for these
channels.
Enable: Click to activate video loss monitoring function.
Trigger: Configure the actions to be taken when the DVR does not receive any video input signal from the connected
camera(s). The settings configuration is similar to Sensor Trigger. See
“Sensor Trigger Settings” on page 47 .
Copy CH/To CH: Copy the current settings to all channels or one specific channel. Click the arrow to select an option
and then click Copy.
After all settings are complete, click Apply.